1.
Follow the procedure in
Before You Begin
.
2.
Remove the computer cover (see
Replacing the Computer Cover
).
3.
Remove the drive cage (see
Removing the Drive Cage
).
4.
Locate the 3-pin CMOS jumper on the system board (see
System Board Components
).
5.
Move the 2-pin jumper plug from pins 3 and 2 to pins 1 and 2.
6.
Wait for five seconds for the CMOS to clear.
7.
Move the 2-pin jumper plug back to pins 3 and 2.
8.
Replace the drive cage (see
Installing the Drive Cage
).
9.
Replace the computer cover (see
Installing the Computer Cover
).
10.
Turn on the computer.
11.
The message
CMOS settings wrong
appears on the screen. Restart the computer.
12.
The message
CMOS checksum error.Press F2 to run setup.Press F1 to load default values and continue
appears on the screen.
13.
Press <F1> to load default values and continue.
Back to Contents Page
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTE:
The computer must be disconnected from the electrical outlet to clear the CMOS setting.
NOTE:
The computer will not turn on if you do not replace the 2-pin jumper on pins 3 and 2.