Dell S6100, Configuration Manual

Page: 995 / 1743

ip msdp sa-limit
Configure the upper limit of source-active (SA) entries in SA-cache.
Syntax ip msdp sa-limit number
To return to the default, use the
no ip msdp sa-limit number
command.
Parameters
number Enter the maximum number of SA entries in SA-cache. The range is from 1 to 500000.
Defaults 50000
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the E-Series.
Usage Information Dell Networking OS counts the SA messages originated by itself and those messages received from the MSDP
peers. When the total SA messages reach this limit, the subsequent SA messages are dropped (even if they pass
RPF checking and policy checking).
If the total number of SA messages is already larger than the limit when this command is applied, those SA
messages that are already in Dell Networking OS continue to be accepted. To enforce the limit in such situation,
use the
clear ip msdp sa-cache
command.
Related Commands
• ip msdp peer — configure the MSDP peer.
• clear ip msdp peer — clear the MSDP peer.
• show ip msdp — display the MSDP information.
Multicast Source Discovery Protocol (MSDP) 995