•
Save the changes and reboot the system for UFT mode profiling to take effect.
hardware forwarding-table mode
Select a mode to initialize the maximum scalability size for L2 MAC table or L3 Host table or L3 Route table.
Syntax
hardware forwarding-table-mode {scaled-l2-switch | scaled-l3-hosts | scaled-l3-
routes}
Parameters
scaled-l2-
switch
Enter the keywords
scaled-l2-switch
to select the forwarding table mode for
scaling l3 switch entries.
scaled-l3–
hosts
Enter the keywords
scaled-l3–hosts
to select the forwarding table mode for scaling
l3 host entries.
scaled-l3–
routes
Enter the keywords
scaled-l3–routes
to select the forwarding table mode for
scaling l3 route entries.
Defaults
UFT mode 2
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell
Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.7(0.0)
Introduced on the S6000, S6000-ON, and Z9500 switch..
Usage Information
This command takes effect only after reboot.
Related Commands
show hardware forwarding-table mode
— displays the hardware forwarding table mode in the current boot and in
the next boot.
show hardware forwarding-table mode
Display the hardware forwarding table mode in the current boot and in the next boot.
Syntax
show hardware forwarding-table mode
Defaults
none
Command Modes
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell
Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Content Addressable Memory (CAM)
461
