Dell S6100, Configuration Manual

Page: 1276 / 1743

policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part of the policy map (output) applied
on an interface.
Syntax policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the
no policy-aggregate qos-policy-name
command.
Parameters
qos-policy-name Enter the name of the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Policy name character limit increased from 16 to 32.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information An aggregate output QoS policy applies to all outbound port traffic. An aggregate output QoS policy can coexist
with per-queue output QoS policies. If the rate shape exists in both aggregate and per-queue qos-policy, minimum
of 2 take effect. Some of all Queue-rate will not exceed aggregate.
Related Commands
• policy-map-input — creates an input policy map.
• policy-map-output — creates an output policy map.
1276 Quality of Service (QoS)