Dell S6100, Configuration Manual

Page: 1258 / 1743

service-class dot1p-mapping
Configure a service-class criterion based on a dot1p value.
Syntax service-class dot1p-mapping {dot1p0 queue | dot1p1 queue | dot1p2 queue |
dot1p3 queue | dot1p4 queue | dot1p5 queue | dot1p6 queue | dot1p7 queue }
Parameters
queue Enter a value from 0 to 7.
Defaults For each dot1p Priority, the default CoS queue value is:
• Dot1p Priority : 0 1 2 3 4 5 6 7
• Queue : 1 0 2 3 4 5 6 7
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information To apply dot1p-queue-mapping, use the
service-class dynamic dot1p
command.
Related Commands
• show qos dot1p-queue-mapping — displays the dot1p priority to queue mapping on the switch.
show qos dot1p-queue-mapping
Displays the dot1p priority to queue mapping on the switch.
Syntax show qos dot1p-queue-mapping
Defaults
1258 Quality of Service (QoS)