Related Commands
•
— sets the password for FTP connections.
ip ftp vrf
Configures an FTP client with a VRF that is used to connect to the FTP server.
Syntax
ip ftp [vrf {
vrf-name
| management}]
To undo the FTP client configuration, use the
ip ftp [vrf
vrf-name
]
command.
Parameters
vrf-name
Enter the
vrf-name
to specify the VRF that is used by the FTP client.
management
Enter the keyword
management
to specify that the VRF used by the FTP client is a
management VRF.
Defaults
Disabled
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.0)
Introduced on the Z9500.
9.4(0.0)
Introduced on the S-Series and Z9000.
Usage Information
Use this command to make the FTP clients VRF-aware. The VRF name that you specify is used by the FTP client
to reach the FTP server. If no VRF name is specified, then the default VRF is used.
ip telnet server enable
Enable the Telnet server on the switch.
Syntax
ip telnet server enable
To disable the Telnet server, use the
no ip telnet server enable
command.
Defaults
Enabled
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Control and Monitoring
107
