Dell S4820T, Configuration Manual

Page: 831 / 1178

Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface Recv Send
TenGigabitEthernet 1/1 2 1 2
Routing for Networks:
10.0.0.0
Routing Information Sources:
Gateway Distance Last Update
Distance: (default is 120)
Dell#
Generating a Default Route
Traffic is forwarded to the default route when the traffic’s network is not explicitly listed in the routing
table.
Default routes are not enabled in RIP unless specified. Use the
default-information originate
command in ROUTER RIP mode to generate a default route into RIP. In Dell Networking OS, default
routes received in RIP updates from other routes are advertised if you configure the
default-
information originate
command.
• Specify the generation of a default route in RIP.
ROUTER RIP mode
default-information originate [always] [metric value ] [route-map route-map-
name ]
–
always
: Enter the keyword
always
to always generate a default route.
–
value
The range is from 1 to 16.
–
route-map-name
: The name of a configured route map.
To confirm that the default route configuration is completed, use the
show config
command in
ROUTER RIP mode.
Summarize Routes
Routes in the RIPv2 routing table are summarized by default, thus reducing the size of the routing table
and improving routing efficiency in large networks.
By default, the
autosummary
command in ROUTER RIP mode is enabled and summarizes RIP routes up
to the classful network boundary.
If you must perform routing between discontiguous subnets, disable automatic summarization. With
automatic route summarization disabled, subnets are advertised.
The
autosummary
command requires no other configuration commands. To disable automatic route
summarization, enter
no autosummary
in ROUTER RIP mode.
NOTE: If you enable the
ip split-horizon
command on an interface, the system does not
advertise the summarized address.
Routing Information Protocol (RIP)
831