2
Assign access and trunk ports to a VLAN (
Creating Access and Trunk Ports
).
3
Enabling VLAN-Stacking for a VLAN
.
Related Configuration Tasks
•
Configuring the Protocol Type Value for the Outer VLAN Tag
•
Configuring Dell Networking OS Options for Trunk Ports
•
•
VLAN Stacking in Multi-Vendor Networks
Creating Access and Trunk Ports
To create access and trunk ports, use the following commands.
•
Access port
— a port on the service provider edge that directly connects to the customer. An access port may belong to only one
service provider VLAN.
•
Trunk port
— a port on a service provider bridge that connects to another service provider bridge and is a member of multiple service
provider VLANs.
Physical ports and port-channels can be access or trunk ports.
1
Assign the role of access port to a Layer 2 port on a provider bridge that is connected to a customer.
INTERFACE mode
vlan-stack access
2
Assign the role of trunk port to a Layer 2 port on a provider bridge that is connected to another provider bridge.
INTERFACE mode
vlan-stack trunk
3
Assign all access ports and trunk ports to service provider VLANs.
INTERFACE VLAN mode
member
Example of Displaying the VLAN-Stack Configuration for a Switchport
To display the VLAN-Stacking configuration for a switchport, use the
show config
command from INTERFACE mode.
Dell#show run interface tengigabitEthernet 1/1
!
interface TenGigabitEthernet 1/1
no ip address
switchport
vlan-stack access
no shutdown
Dell#show run interface tengigabitEthernet 1/2
!
interface TenGigabitEthernet 1/2
no ip address
switchport
vlan-stack trunk
no shutdown
Service Provider Bridging
837
Summary of Contents for S4048T-ON
