Dell S4048-ON, Configuration Manual

Page: 762 / 1039

line console 0
login authentication test
authorization exec test
exec-timeout 0 0
line vty 0
login authentication test
authorization exec test
line vty 1
login authentication test
authorization exec test
To enable role-based only AAA authorization:
Dell(conf)#aaa authorization role-only
System-Defined RBAC User Roles
By default, the Dell Networking OS provides 4 system defined user roles. You can create up to 8 additional user roles.
NOTE: You cannot delete any system defined roles.
The system defined user roles are as follows:
• Network Operator (netoperator) - This user role has no privilege to modify any configuration on the switch. You can access Exec
mode (monitoring) to view the current configuration and status information.
• Network Administrator (netadmin): This user role can configure, display, and debug the network operations on the switch. You
can access all of the commands that are available from the network operator user role. This role does not have access to the
commands that are available to the system security administrator for cryptography operations, AAA, or the commands reserved
solely for the system administrator.
• Security Administrator (secadmin): This user role can control the security policy across the systems that are within a domain or
network topology. The security administrator commands include FIPS mode enablement, password policies, inactivity timeouts,
banner establishment, and cryptographic key operations for secure access paths.
• System Administrator (sysadmin). This role has full access to all the commands in the system, exclusive access to commands
that manipulate the file system formatting, and access to the system shell. This role can also create user IDs and user roles.
The following summarizes the modes that the predefined user roles can access.
Role Modes
netoperator
netadmin Exec Config Interface Router IP Route-map Protocol MAC
secadmin Exec Config Line
sysadmin Exec Config Interface Line Router IP Route-map Protocol MAC
User Roles
This section describes how to create a new user role and configure command permissions and contains the following topics.
• Creating a New User Role
• Modifying Command Permissions for Roles
• Adding and Deleting Users from a Role
Creating a New User Role
Instead of using the system defined user roles, you can create a new user role that best matches your organization. When you create
a new user role, you can first inherit permissions from one of the system defined roles. Otherwise you would have to create a user
762
Security