Dell S3048-ON, Configuration Manual

Page: 422 / 1036

The default is 32768 .
LACP Configuration Tasks
The following configuration tasks apply to LACP.
• Creating a LAG
• Configuring the LAG Interfaces as Dynamic
• Setting the LACP Long Timeout
• Monitoring and Debugging LACP
• Configuring Shared LAG State Tracking
Creating a LAG
To create a dynamic port channel (LAG), use the following command. First you define the LAG and then the LAG interfaces.
• Create a dynamic port channel (LAG).
CONFIGURATION mode
interface port-channel
• Create a dynamic port channel (LAG).
CONFIGURATION mode
switchport
Example of Configuring a LAG Interface
Dell(conf)#interface port-channel 32
Dell(conf-if-po-32)#no shutdown
Dell(conf-if-po-32)#switchport
The LAG is in the default VLAN. To place the LAG into a non-default VLAN, use the
tagged
command on the LAG.
Dell(conf)#interface vlan 10
Dell(conf-if-vl-10)#tagged port-channel 32
Configuring the LAG Interfaces as Dynamic
After creating a LAG, configure the dynamic LAG interfaces.
To configure the dynamic LAG interfaces, use the following command.
• Configure the dynamic LAG interfaces.
CONFIGURATION mode
port-channel-protocol lacp
Example of the
port-channel-protocol lacp
Command
Dell(conf)#interface Gigabitethernet 3/15
Dell(conf-if-gi-3/15)#no shutdown
Dell(conf-if-gi-3/15)#port-channel-protocol lacp
Dell(conf-if-gi-3/15-lacp)#port-channel 32 mode active
...
Dell(conf)#interface Gigabitethernet 3/16
Dell(conf-if-gi-3/16)#no shutdown
Dell(conf-if-gi-3/16)#port-channel-protocol lacp
Dell(conf-if-gi-3/16-lacp)#port-channel 32 mode active
...
422 Link Aggregation Control Protocol (LACP)