Dell Precision 610, User Manual, Page: 58 / 230

3-18 Dell Precision 610 Mini Tower Systems User’s Guide
a new system password if the Disabled by Jumper option is displayed. When a
system password is not assigned, the System Password
setting shown is Not
Enabled.
To assign a system password, follow these steps:
9HULI\ WKDW WKH 3DVVZRUG 6WDWXV VHWWLQJ LV VHW WR 8QORFNHG
For instructions on changing this setting, see “Password Status” found earlier in
this chapter.
+LJKOLJKW WKH 6\VWHP 6HFXULW\ VHWWLQJ DQG SUHVV (QWHU!
+LJKOLJKW WKH 6\VWHP 3DVVZRUG VHWWLQJ DQG SUHVV (QWHU!
7\SH WKH GHVLUHG V\VWHP SDVVZRUG LQ WKH (QWHU 3DVVZRUG ILHOG DQG
SUHVV (QWHU!
You can use up to seven characters in your password.
As you press each character key (or <Spacebar> for a blank space), a placeholder
appears in the field.
The password assignment operation recognizes keys by their location on the key-
board, without distinguishing between lowercase and uppercase characters. For
example, if you have an
M in your password, the system recognizes either M or m
as correct.
Certain key combinations are not valid. If you enter one of these combinations,
the speaker emits a beep.
To erase a character when entering your password, press <Backspace> or the
left-arrow key.
NOTE: To escape from the field without assigning a system password, press
<Esc>.
7\SH WKH GHVLUHG V\VWHP SDVVZRUG LQ WKH &RQILUP 3DVVZRUG ILHOG DQG
SUHVV (QWHU!
The system password is now assigned and is Enabled. You can exit the System
Setup program and begin using your system. Password protection takes effect
after the system reboots.