Managing SMI-S Provider
13
3
Managing SMI-S Provider
Starting and Stopping the OpenPegasus CIM
Server
For Windows
To
start
or
stop
the OpenPegasus CIM server:
• Open the
Services
window and locate the
cimserver
service. Right-click
cimserver
service and select
start
or
stop
.
Or
• In the command prompt:
To start the service, type:
net start cimserver
To stop the service, type:
net stop cimserver
For Linux
To
start
or
stop
the OpenPegasus CIM server, on a terminal window:
To start the service, type:
cimserver
To stop the service, type:
cimserver -s
Adding or Removing a Storage Array From SMI-S
Provider
At installation, you are prompted to enter the IP addresses into a file. After
this initial setup, the SMI-enabled client must use the SMI-S Provider proxy
server system management profile to add or remove devices.
NOTE:
When a storage array is added, an IP address of only one of the
management ports of the storage array must be supplied (and not both
management ports). Entering the IP addresses for both management ports of a
single storage array causes unpredictable behavior of the SMI-S Provider.
book.book Page 13 Friday, July 9, 2010 2:13 PM