Dell PowerVault 35F, Installation Manual

Page: 7 / 50

Dell PowerVault 35F Fibre Channel Bridge Rack Installation Guide 1-3
‡
Ensure that the rack is level and stable before extending a component from the
rack.
‡
After a component is inserted into the rack, carefully extend the slide into a
locking position, and then slide the component into the rack.
5HFRPPHQGHG7RRO
To install the PowerVault 35F bridge, use a #2 Phillips-head screwdriver.
,QVWDOOLQJWKH%ULGJH
Use the following procedure to install the bridge in the rack. The subsections that
follow include instructions for performing these tasks.
1. Remove the doors from the rack.
2. Mount the bridge onto the manifold.
3. Install the outer slides.
4. Install the bridge in the rack.
5. Replace the doors.
5HPRYLQJWKH'RRUV)URPWKH5DFN
You must remove the front and back doors from the rack to provide access to the
interior of the rack and to prevent damage to the doors while installing the kit. Use
the following procedure to remove the doors.
:$51,1*7RSUHYHQWSHUVRQDOLQMXU\GXHWRWKHVL]HDQGZHLJKWRIWKH
GRRUVQHYHUDWWHPSWWRUHPRYHWKHGRRUVE\\RXUVHOI
1. Open the latch on the front door (see Figure 1-1).
Slide the latch’s push-button cover up as far as it will go, press the push button,
rotate the handle clockwise until the latch releases, and then pull the door open.