Remove the NVRAM module
Prerequisites
Follow the safety guidelines listed in
on page 13.
About this task
NOTE:
This procedure describes and illustrates NVRAM module removal from slot 2 in expansion card riser 1.
Steps
1. If applicable, disconnect the cables from the expansion card in slot 1 (the top slot in riser 1).
2. Hold the expansion card by its edges, pull the card until the card edge connector disengages from the expansion card
connector on the riser, and place it on an ESD-safe surface.
3. Remove the NVRAM module from slot 2 (the middle slot in riser 1)
Figure 33. Removing the NVRAM module from expansion card riser 1
Figure 34. NVRAM module
72
Replace an NVRAM module
