Dell PowerConnect W-Series SFP
| Installation Guide
3
LC Fiber Optic Cable Connection
To connect an LC fiber optic cable into an SFP-SX or SFP-LX module:
1. Insert the fiber optic cable into the SFP module. Ensure that the latch on the cable faces the top of the SFP
module.
2. Slide the cable into place until a connection is made and an audible click is heard.
To disconnect an LC fiber optic cable from an SFP-SX or SFP-LX module:
3. Depress to release the latch on the cable and simultaneously pull the cable out of the port.
SFP Removal
To remove an SFP module:
1. Use standard ESD precautions when removing an SFP module.
2. Open and release the latch on the SFP module.
3. Pull and remove the module from the port.
Safety and Regulatory Compliance
To view or download a multi-language document containing country specific restrictions and additional safety
and regulatory information, refer to the installation guide that shipped with your controller/switch.
This product complies with 21 CFR Chapter 1, Subchapter J, Part 1040.10, and IEC 60825-
1: 1993, A1: 1997, A2: 2001, IEC 60825-2: 2000.
For continued compliance with the above laser safety standards, only approved Class 1
modules from our approved vendors should be installed.
Proper Disposal of Dell Equipment
For the most current information on Global Environmental Compliance and Dell products please refer to the
Dell PowerConnect W-Series Safety, Environmental, and Regulatory Information
document is included with this
product or see our website at
www.dell.com
.
European Union RoHS
Dell products also comply with the EU Restriction of Hazardous Substances Directive
2002/95/EC (RoHS). EU RoHS restricts the use of specific hazardous materials in the
manufacture of electrical and electronic equipment. Specifically, restricted materials
under the RoHS Directive are Lead (including Solder used in printed circuit assemblies), Cadmium, Mercury,
Hexavalent Chromium, and Bromine. Some Dell products are subject to the exemptions listed in RoHS Directive
Annex 7 (Lead in solder used in printed circuit assemblies). Products and packaging will be marked with the
“RoHS” label shown at the left indicating conformance to this Directive.
CLASS 1
LASER PRODUCT
Note: Use of controls or adjustments of performance or procedures other than those specified in this manual may result in
hazardous radiation exposure.
