6
Dell PowerConnect W-IAP130 Series Instant Access Point
| Installation Guide
Installing the AP
Using the Ceiling Rail Adapter
The access point ships with two ceiling rail adapters for 9/16” and 15/16” ceiling rails.
1. Pull the necessary cables through a prepared hole in the ceiling tile near where the AP will be placed.
2. Place the adapter against the back of the AP with the adapter at an angle of approximately 30 degrees to the
tabs (see
Figure 3
).
3. Twist the adapter clockwise until it snaps into place in the tabs (see
Figure 3
).
Figure 3
Attaching the Ceiling Rail Adapter
4. If necessary, connect the console cable to the console port on the back of the AP.
CAUTION: Installation and service of Dell PowerConnect W-Series products should be performed by Professional Installers.
CAUTION: Make sure the AP fits securely on the ceiling tile rail when hanging the device from the ceiling, because poor
installation could cause it to fall onto people or equipment.
AP-130_001
