About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Steps
1. Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
2. Replace the five screws (M1.6x2.5) that secure the battery to the palm-rest and keyboard assembly.
3. Connect the battery cable to the system board.
Next steps
1. Install the
.
After working inside your computer
.
Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
Before working inside your computer
.
CAUTION:
Solid-state drives are fragile. Exercise care when handling the solid-state drive.
CAUTION:
To avoid data loss, do not remove the solid-state drive while the computer is in sleep or on state.
2. Remove the
.
About this task
NOTE:
Depending on the configuration ordered, your computer may support an M.2 2230 solid-state drive or an M.2 2280
solid-state drive.
NOTE:
This procedure applies only to computers shipped with an M.2 2230 solid-state drive.
Removing and installing components
17
