Installing 3.5–inch hard drive into the hard drive bracket
1
Flex the side of the hard drive bracket, to align and insert the pins on the bracket into the hard drive.
2
Insert the hard drive into the hard drive bracket until it clicks into place.
3
Install the:
a
b
c
4
Follow the procedure in
After working inside your computer
.
Installing 3.5–inch hard drive assembly
1
Insert the hard drive assembly into the slot on the computer until it clicks into place.
2
Place the HDD filler brcaket.
3
Connect the SATA cable and the power cable to the connectors on the hard drive and re-route the cables along the caddy.
4
Install the:
a
b
5
Follow the procedure in
After working inside your computer
.
Removing 2.5–inch hard drive assembly
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
3
.
4
To remove hard drive assembly:
a Disconnect the hard drive's data and power cables from their respective connectors on the hard drive [1].
b Press the blue tabs on both sides [2] and pull the drive assembly out of the computer [3].
18
Disassembly and reassembly
Summary of Contents for OptiPlex 5055 Tower
Page 1: ...Dell OptiPlex 5055 Tower Owner s Manual Regulatory Model D18M Regulatory Type D18M004 ...
Page 12: ...4 Lift the front bezel to remove it from the computer 12 Disassembly and reassembly ...
Page 44: ...b Slide and lift the system board away from the computer 2 44 Disassembly and reassembly ...
