Option
Description
•
Disabled
- Does not allows the system to power on by special LAN signals when it receives a
wake-up signal from the LAN or wireless LAN.
•
LAN
or
WLAN
- Allows the system to be powered on by special LAN or wireless LAN signals.
•
LAN Only
- Allows the system to be powered on by special LAN signals.
•
LAN with PXE Boot
- A wakeup packet sent to the system in either the S4 or S5 state, that will
cause the system to wake-up and immediately boot to PXE.
•
WLAN Only
- Allows the system to be powered on by special WLAN signals.
This option is Disabled by default.
Block Sleep
Allows you to block entering to sleep (S3 state) in OS environment. This option is disabled by default.
Post behavior
Table 26. POST Behavior
Option
Description
Numlock LED
Allows you to enable or disable the Numlock feature when your computer starts. This option is
enabled by default.
Keyboard Errors
Allows you to enable or disable the keyboard error reporting when the computer starts. The option
Enable Keyboard Error Detection
is enabled by default.
Fast Boot
This option can speed up the boot process by bypassing some compatibility steps:
•
Minimal — The system boots quickly, unless the BIOS has been updated, memory changed, or
the previous POST did not complete.
•
Thorough — The system does not skip any steps in the boot process.
•
Auto — This allows the operating system to control this setting (this works only when the
operating system supports Simple Boot Flag).
This option is set to
Thorough
by default.
Extend BIOS POST Time
This option creates an additional pre-boot delay.
•
0 seconds (default)
•
5 seconds
•
10 seconds
Full Screen Logo
This option will display full screen logo if your image match screen resolution. The option
Enable Full
Screen Logo
is not set by default.
Warnings and Errors
This option causes the boot process to only pause when warning or errors are detected. Choose any
one of the option:
•
Prompt on Warnings and Errors
•
Continue on Warnings
•
Continue on Warnings and Errors
System setup
25
