11
| W-7024 Controller
Dell Networking W-7024 Controller | Installation Guide
l
LINK/ACT—
Placed on the left side of the port, this LED displays the link status and activity of the port.
l
STATUS—
Placed on the right side of the port, this LED displays the status of the port. The information
displayed by this LED changes based on the LCD mode. The LED behavior corresponding to each LCD mode
is listed in
LED
Function
LCD Mode
Indicator
Status
LINK/ACT
Link status
Link status
Green (Solid)
Link established
Green (Blinking)
Port is transmitting or receiving data
Off
No link
STATUS
Port status
Administrative
Green (Solid)
Port enabled
Off
Port administratively disabled
Duplex
Green (Solid)
Full-duplex
Off
Half-duplex
PoE
Green (Solid)
PoE enabled
Green (Blinking)
Power enabled, but power denied due to unavailability
Off
PoE not enabled
Speed
Green (Solid)
1000 Mbps
Off
10/100 Mbps
Table 5:
10/100/1000BASE-T Port LEDs
Uplink Ports
The W-7024 controller is equipped with two 10GBase-X (SFP+) uplink ports (24 and 25). These ports are intended
for use with SFP/SFP+. See
.
Figure 4:
10GBase-X Ports, LCD Panel, and LEDs
Uplink Port LEDs
Each 10GBASE-X port is equipped with two LEDs that allow basic monitoring of status, activity, and configuration
of the port. The behavior of the STATUS LED can be changed using the LCD.
l
LINK/ACT—
Placed on the top left of the port, this LED displays the link status and activity of the port.
