Dell Networking S6000 System, Reference Manual, Page: 956 / 1510

33
Multicast
The multicast commands are supported by Dell Networking operating system (OS) on all S6000 platform.
This chapter contains the following sections:
• IPv4 Multicast Commands
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent
multicast (PIM) tree information base, use the
clear ip pim tib
command.
S6000
Syntax
clear ip mroute { group-address [ source-address ] | * | snooping}
Parameters
group-address
[ source-
address ]
Enter the multicast group address and source address (if
desired), in dotted decimal format, to clear information on a
specific group.
* Enter * to clear all multicast routes.
snooping Enter the keyword
snooping
to delete multicast snooping
route table entries.
Command
Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0) Added support for keyword
snooping
on the Z9000, S4810,
and S4820T.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
956
Multicast