Dell Networking S6000 System, Reference Manual

Page: 916 / 1510

advertise med video-signaling
To advertise video control packets that use a separate network policy than video data, configure the
system.
S6000
Syntax
advertise med video-signaling { vlan-id layer2_priority
DSCP_value } | {priority-tagged number }
To return to the default, use the
no advertise med video-signaling
{ vlan-id layer2_priority DSCP_value } | {priority-tagged number }
command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority (C-Series and E-Series only). The
range is from 0 to 7.
DSCP_value Enter the DSCP value (C-Series and E-Series only). The range
is from 0 to 63.
priority-tagged
number
Enter the keywords
priority-tagged
then the Layer 2
priority. The range is from 0 to 7.
Defaults unconfigured.
Command
Modes CONFIGURATION (conf-lldp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series and E-Series.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
916
Link Layer Discovery Protocol (LLDP)