Dell Networking S6000 System, Reference Manual

Page: 897 / 1510

29
Link Layer Discovery Protocol (LLDP)
The link layer discovery protocol (LLDP) advertises connectivity and management from the local station
to the adjacent stations on an IEEE 802 LAN.
This chapter contains the following sections:
• LLPD Commands
• LLDP-MED Commands
LLDP facilitates multi-vendor interoperability by using standard management tools to discover and make
available a physical topology for network management. The Dell Networking operating software
implementation of LLDP is based on IEEE standard 801.1ab.
TheDell Networking OS supports the basic LLDP commands on S6000 platform.
The starting point for using LLDP is invoking LLDP with the
protocol lldp
command in either
CONFIGURATION or INTERFACE mode.
The information LLDP distributes is stored by its recipients in a standard management information base
(MIB). You can access the information by a network management system through a management
protocol such as simple network management protocol (SNMP).
LLPD Commands
The following are LLDP commands.
advertise dot1-tlv
Advertise dot1 TLVs (Type, Length, Value).
S6000
Syntax
advertise dot1-tlv {port-protocol-vlan-id | port-vlan-id |
vlan-name}
To remove advertised dot1-tlv, use the
no advertise dot1-tlv {port-
protocol-vlan-id | port-vlan-id | vlan-name}
command.
Parameters
port-protocol-
vlan-id Enter the keywords
port-protocol-vlan-id
to advertise
the port protocol VLAN identification TLV.
port-vlan-id Enter the keywords
port-vlan-id
to advertise the port
VLAN identification TLV.
Link Layer Discovery Protocol (LLDP)
897