port-channel
number
Enter the keywords
port-channel
then an existing LAG
number. Enter this keyword/variable combination twice,
identifying the two paired LAGs.
Defaults
none
Command
Modes
PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Version 8.1.1.0
Introduced on the E-Series ExaScale.
Version 7.6.1.0
Introduced on the C-Series, E-Series, and S-Series.
Related
Commands
— accesses PORT-CHANNEL FAILOVER-GROUP
mode to configure a LAG failover group.
— displays information on configured Port Channel
groups.
interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing eight physical
interfaces on the S-Series.
S6000
Syntax
interface port-channel
channel-number
To delete a Port Channel, use the
no interface port-channel
channel-
number
command.
Parameters
channel-
number
For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
Defaults
Not configured.
Command
Modes
CONFIGURATION
692
Interfaces
Summary of Contents for Networking S6000 System
