Dell Networking S6000 System, Reference Manual

Page: 475 / 1510

fcoe priority-bits
Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
S6000
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the
no fcoe priority-bits
command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x8
Command
Modes PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information This command is available at the global level only.
iscsi priority-bits
Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
S6000
Syntax
iscsi priority-bits priority-bitmap
To remove the configured iSCSI priority, use the
no iscsi priority-bits
command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x10
Data Center Bridging (DCB)
475