Dell Networking S6000 System, Reference Manual

Page: 391 / 1510

Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced the ability to substitute IGP cost for MED when a
peer/peer-group outbound route-map is set as
internal .
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
You can use the
redistribute
command to advertise the IGP cost as the MED
on redistributed routes. When you set the route-map with metric-type internal and
applied outbound to an EBGP peer/peer-group, the advertised routes
corresponding to those peer/peer-groups have the IGP cost set as
MED .
If you do not configure the
default-metric
command, in addition to the
redistribute
command, or there is no route map to set the metric, the metric
for redistributed static and connected is “0”.
To redistribute the default route (0.0.0.0/0), configure the
neighbor default-
originate
command.
As BGP does not query next-hop information corresponding to locally originated
routes, a local route with an unreachable next-hop is chosen as the best route.
When a combination of locally originated and peer originated routes occurs, both
these routes will exist in the RTM. However, only the best route is kept active in the
RTM and the remaining route is rendered in-active.
It is possible to keep only one locally originated route in the BGP database.
Network command has preference over the re-distributed routes. When the locally
originated route is no longer present in the database the other route is
automatically installed.
Related
Commands neighbor default-originate — injects the default route.
redistribute ospf
Redistribute OSPF routes into BGP.
S6000
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name ]
To stop redistribution of OSPF routes, use the
no redistribute ospf
process-id
command.
Border Gateway Protocol
391