neighbor advertisement-start
To send BGP routing updates, set the minimum interval before starting.
S6000
Syntax
neighbor {
ip-address
} advertisement-start
seconds
To return to the default value, use the
no neighbor {
ip-address
}
advertisement-start
command.
Parameters
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
seconds
Enter a number as the time interval, in seconds, before BGP
route updates are sent. The range is from 0 to 3600 seconds.
Defaults
none
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Version 7.8.1.0
Introduced on the S-Series.
Version 7.7.1.0
Introduced on the C-Series.
neighbor allowas-in
Set the number of times an AS number can occur in the AS path.
S6000
Syntax
neighbor {
ip-address
|
peer-group-name
} allowas-in
number
To return to the default value, use the
no neighbor {
ip-address
|
peer-
group-name
} allowas-in
command.
Parameters
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
364
Border Gateway Protocol
Summary of Contents for Networking S6000 System
