Dell Networking S6000 System, Reference Manual

Page: 244 / 1510

match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other
routers.
match metric — redistributes routes that match a specific metric.
match tag — redistributes routes that match a specific tag.
match tag
To redistribute only routes that match a specified tag value, configure a filter.
S6000
Syntax
match tag tag-value
To remove a match, use the
no match tag
command.
Parameters
tag-value Enter a value as the tag on which to match. The range is
from zero (0) to 4294967295.
Defaults Not configured.
Command
Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Related
Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
244
Access Control Lists (ACL)