Dell Networking S6000 System, Reference Manual

Page: 1510 / 1510

version
Set VRRP protocol version for IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the
no version
command.
Parameters
2 Enter the
2
parameter to specify VRRP version 2 as defined
by RFC 3768, Virtual Router Redundancy Protocol.
3 Enter the
2
parameter to specify VRRP version 3 as defined
in RFC 5798, Virtual Router Redundancy .
both Enter the
both
keyword for in-service migration from VRRP
version 2 to VRRP version 3.
Defaults 2
Command
Modes VRRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage
Information You can use the version
both
command to migrate from VRRPv2 to VRRPv3. When
you set the VRRP protocol version to both, the switch sends only VRRPv3
advertisements but can receive either VRRPv2 or VRRPv3 packets. To migrate an
IPv4 VRRP group from VRRPv2 to VRRPv3:
1. Set the switches with the lowest priority to “both”.
2. Set the switch with the highest priority to version to 3.
3. Set all the switches from both to version 3.
NOTE: Do not run VRRP version 2 and version 3 in the same group for an
extended period of time.
Example
Dell(conf-if-te-0/0-vrid-100)#version ?
2 VRRPv2
3 VRRPv3
both Interoperable, send VRRPv3 receive
both
Dell(conf-if-te-0/0-vrid-100)#version 3
1510
Virtual Router Redundancy Protocol (VRRP)