show vlt statistics igmp-snoop
Displays the informational packets and IGMP control PDUs that are exchanged between VLT peer nodes.
S6000
Syntax
show vlt statistics igmp-snoop
Default
Not configured.
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Example
Dell_VLTpeer1#show vlt statistics igmp-snoop
VLT Igmp-Snooping Statistics
-------------------------------
IGMP Info Pkts sent: 4
IGMP Info Pkts Rcvd: 1
IGMP Reg Request sent: 1
IGMP Reg Request rcvd: 2
IGMP Reg Response sent: 1
IGMP Reg Response rcvd: 1
IGMP PDU Tunnel Pkt sent:5
IGMP PDU Tunnel Pkt rcvd:10
IGMP Tunnel PDUs sent: 10
IGMP Tunnel PDUs rcvd: 19
unit-id
Explicitly configure the default unit ID of a VLT peer switch.
S6000
Syntax
unit-id [0 | 1]
Parameters
0 | 1
Configure the default unit ID of a VLT peer switch. Enter
0
for the first peer or enter
1
for the second peer.
Virtual Link Trunking (VLT)
1477
Summary of Contents for Networking S6000 System
