ip vrf forwarding
Enables you to attach an interface to a VRF.
Syntax
ip vrf forwarding {
vrf-name
|
management
}
To delete an interface associated with a configured VRF, use the
no ip vrf
forwarding {
vrf-name
|
management
}
command.
Parameters
vrf-name
Enter the name of the VRF that you want to create.
management
Enter the name of the management VRF.
Defaults
None (Interface is part of default VRF).
Command
Modes
INTERFACE-CONFIG
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Version 8.2.1.0
Introduced on the E-Series.
Version
Introduced on the S4810.
Version
Introduced on the S-Series.
Version
Introduced on the C-Series.
Version
Introduced support for telnetting to the VRRP group IP
address assigned using this command.
pre-Version
Introduced on the E-Series.
Usage
Information
Use this command to attach an interface to a configured VRF. You can attach an
interface to either a non-default VRF or a management VRF. To assign a port-back
to a default VRF, remove the interface associated with the VRF. You can use this
only if there is no IP address configured on the interface.
There must be no prior Layer 3 configuration on the interface when configuring
VRF.
VRF must be enabled prior to implementing this command.
You can configure an IP subnet or address on a physical or VLAN interface that
overlaps the same IP subnet or address configured on another interface only if the
Virtual Routing and Forwarding (VRF)
1449
Summary of Contents for Networking S6000 System
