Dell Networking S6000 System, Reference Manual

Page: 1375 / 1510

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series, S55.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information To block a type of message parameter, set the logging trap level to a lower
number. For example, to block severity messages at level 6, set the level to 5.
Related
Commands
logging — enables the logging to another device.
logging on — enables logging.
logging version
Displays syslog messages in a RFC 3164 or RFC 5424 format.
Syntax
logging version {0|1}
Defaults
0
Command
Modes CONFIGURATION
Version 9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Usage
Information
To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version
command in configuration mode. By default, the system log version is set to 0 .
The following describes the two supported log messages formats:
•
0
– Displays syslog messages format as described in RFC 3164, The BSD syslog
Protocol
•
1
– Displays SYSLOG message format as described in RFC 5424, The Syslog
Protocol
Simple Network Management Protocol (SNMP) and Syslog
1375