Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Version 7.6.1.0
Introduced on the S-Series.
Version 7.5.1.0
Introduced on the C-Series.
E-Series legacy
command
Related
Commands
— limit messages logged to the Syslog servers based on severity.
logging
Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple
logging servers of both IPv4 and/or IPv6 can be configured.
S6000
Syntax
logging {
ip-address
|
ipv6-address
|
hostname
} {{udp {
port
}} |
{tcp {port}} [vrf
vrf-name
]
To disable logging, use the
no logging
command.
Parameters
ip-address
Enter the IPv4 address in dotted decimal format.
ipv6-address
Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
hostname
Enter the name of a host already configured and recognized
by the switch.
udp
Enter the keyword
udp
to enable transmission of log
message over UDP followed by port number. The default
port is 514
tcp
Enter the keyword
tcp
to enable transmission of log
message over TCP followed by port number.
1362
Simple Network Management Protocol (SNMP) and Syslog
Summary of Contents for Networking S6000 System
