Dell N1100-ON, Reference Manual

Page: 796 / 2332

Layer 2 Switching Commands
796
protocol vlan group
Use the protocol vlan group command in Interface Configuration mode to
add the physical unit/slot/port interface to the protocol-based group
identified by groupid. A group may have more than one interface associated
with it. Each interface and protocol combination can be associated with one
group only. If adding an interface to a group causes any conflicts with
protocols currently associated with the group, this command fails and the
interface(s) are not added to the group. Ensure that the referenced VLAN is
created prior to the creation of the protocol-based group except when GVRP
is expected to create the VLAN.
To remove the interface from this protocol-based VLAN group that is
identified by this groupid, use the no form of this command.
If you select all , all ports are removed from this protocol group.
Syntax
protocol vlan group group-id
no protocol vlan group group-id
• group-id — The protocol-based VLAN group ID, which is automatically
generated when you create a protocol-based VLAN group with the vlan
protocol group command. To see the group ID associated with the name
of a protocol group, use the show port protocol all command.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to add an Ethernet interface to the group
ID of “2.”