Dell N1100-ON, Reference Manual

Page: 625 / 2332

Layer 2 Switching Commands
625
console(config)# interface range port-channel 1-2,8
console(config-if)#
hashing-mode
Use the hashing-mode command to set the hashing algorithm on trunk ports.
Use the no hashing-mode command to set the hashing algorithm on trunk
ports to the default.
Syntax
hashing-mode mode
• mode — Mode value in the range of 1 to 7.
Range: 1–7:
• 1 — Source MAC, VLAN, EtherType, source module, and port ID
• 2 — Destination MAC, VLAN, EtherType, source module, and port ID
• 3 — Source IP and source TCP/UDP port
• 4 — Destination IP and destination TCP/UDP port
• 5 — Source/destination MAC, VLAN, EtherType, and source
MODID/port
• 6 — Source/destination IP and source/destination TCP/UDP port
• 7 — Enhanced hashing mode. This mode is not available on Dell EMC
Networking N1100-ON/N1500 Series switches.
Default Configuration
The default hashing mode is 7—Enhanced hashing mode. On Dell EMC
Networking N1100-ON/N1500 Series switches, the default hashing mode is 5.
Command Mode
Interface Configuration (port-channel) mode