Dell N1100-ON, Reference Manual

Page: 2175 / 2332

Switch Management Commands
2175
logout
Use this command to disconnect the serial connection to the remote unit on
the stack member.
Syntax
logout
Default Configuration
There is no default configuration for this command.
Command Modes
User Exec mode on the stack master. Unit prompt on the stack member.
User Guidelines
This command is available in User Exec mode on the master unit serial port
and from the Unit prompt on member unit serial ports. The user need not be
currently connected over the serial port to connect to another unit.
The stack member being connected to must be up and running and
connected as part of the stack.
This command is an alias for the
exit command.
Example
(Example 1:
To disconnect a remote session to stack master established from a stack
member.
Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1
Stack-Master#
Stack-Master#logout
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>
Example 2:
To disconnect a remote session to stack master established from a stack
member.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1
Stack-Master#exit
Stack-Master> logout