Dell N1100-ON, Reference Manual

Page: 2002 / 2332

Switch Management Commands
2002
Command Modes
Privileged Exec
User Guidelines
If no interface is specified, the statistics are cleared for all PoE-capable
interfaces.
show power inline
Use the show power inline command to report current PoE configuration and
status. If no port is specified, the command displays global configuration and
status of all the ports. If a port is specified, then the command displays the
details for the single port. Use the detailed parameter to show power limits,
detection type and high power mode for the interface.
Syntax
show power inline [interface-id] [detailed]
• interface-id—Any PoE-capable physical interface. See Interface Naming
Conventions for interface representation.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
If a port supplying power detects PSE equipment, the power to the port is
shut off. If a powered port shows input power detected status (0x24), and no
device is attached, the port should not be used as a possible short may exist.
The PoE controller returns the Total Power Consumed value in Watts. For
this reason, Total Power Consumption value displayed might not exactly
match the sum of power in milliwatts consumed by various Powered Devices.
Examples
In the next example, the port is specified and the command displays the
configuration and status for the specified port.
console#show power inline gigabitethernet 1/0/13