Dell N1100-ON, Reference Manual

Page: 1730 / 2332

Layer 3 Routing Commands
1730
Syntax
default-metric metric-value
no default-metric
• metric-value — The metric (or preference) value of the default route.
(Range: 1–16777214)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets a default of 100 for the metric of distributed
routes.
console(config)#ipv6 router ospf
console(config-rtr)#default-metric 100
distance ospf
The distance ospf command sets the preference values of OSPF route types
in the router. Lower route preference values are preferred when determining
the best route. The type of OSPF route can be intra, inter, external. All the
external type routes are given the same preference value. Use the “no” form of
this command to reset the preference values to the default.
Syntax
distance ospf { external | inter-area | intra-area } distance
no distance ospf { external | inter-area | intra-area } distance
• distance— Used to select the best path when there are two or more routes
to the same destination from two different routing protocols (Range: 1–
255).