44
Troubleshooting
TEMP LED is blinking
amber
If the projector fan fails, the projector will
automatically shut down. Clear the projector
mode by pressing and holding the
POWER
button for 10 seconds. Please wait for about
5 minutes and try to power up again. If the
problem persists, contact Dell.
The OSD does not appear
on the screen
Press the Menu button on the panel for 15
seconds to unlock the OSD.
The remote control is not
operating smoothly or works
only within a limited range
The battery may be low. Check if the LED
indication from the remote is too dim. If so,
replace with a new CR2032 battery.
USB Display not displaying
Display over USB Should run automatically.
To manually run USB display, go to My
Computer and run "Dell Network Projection
Lite.exe".
NOTE:
You may require
administrator level access to install
the driver. Contact your network
administrator for support.
Video file is not supported.
•
Ensure the video file is supported by the
projector's multimedia player. Go to pages
24-24 for Multimedia File Type Support.
•
Convert the video file to meet the following
parameters:
Video Setting:
•
Code: H.264
•
Bit rate: 10Mbps
(if it is limited by
program, set it as maximum value
allowed)
•
Frame rate: 30 fps
(if it is limited
by program, set it as maximum
value allowed)
Audio Setting:
•
Code: AAC
•
Channel: Stereo
•
Sample rate: 48 KHz
•
Bit rate: 96 KBps
Problem
(continued)
Possible Solution
(continued)