Dell Latitude 5430, Service Handbook

Page: 40 / 110

Steps
1. Align the screw hole on the LED board with the screw hole on the palm-rest assembly.
2. Replace the (M2x3) screw to secure the LED board to the palm-rest assembly.
3. Route the LED-board cable and connect the cable to the connector on the system board.
Next steps
1. Install the 3-cell battery or 4-cell battery .
2. Install the base cover .
3. Install the microSIM card .
4. Install the microSD card .
5. Follow the procedure in after working inside your computer .
Kylfläns
Removing the heat-sink assembly
Prerequisites
1. Follow the procedure in before working inside your computer .
CAUTION: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to
cool before you touch it.
2. Remove the microSD card .
3. Remove the microSIM card .
4. Remove the base cover .
5. Remove the 3-cell battery or 4-cell battery .
About this task
The following image indicates the location of the heat-sink assembly and provides a visual representation of the removal
procedure.
40 Ta bort och installera komponenter