NOTE:
Micro-SIM card slot is available only on tablets shipping with WWAN module.
b
3
To remove the front camera:
a Remove the conductive tape covering the shielding cover [1].
NOTE:
Ensure to pull the conductive tape gently to reuse in installing the front camera.
b Lift the shielding cover covering the front cameracable connected to the system board[2].
c Use a plastic scribe to disconnect the front camera cable [3]
NOTE:
Ensure to peel off the adhesive tape that secures the front camera to the rear camera. The front camera cable
is glued to the rear camera, ensure to gently peel off, to remove the screw that secures the rear camera to the system
board.
d Remove the M1.6 x 3.0 screws (2) securing the front camera module [4].
e Lift the front camera module from the tablet [5].
Installing the front camera
1
Insert the camera module into the slot on the tablet.
2
Replace the M1.6 x 3.0 screws to secure the front camera module.
3
Connect the front camera cable to the system board.
4
Place the covering shield to cover the front camera module.
NOTE:
Handle the covering shield with care else it may break.
5
Affix the tape to secure the shield cover.
6
Install the:
a
b
Removing and installing components
23
Summary of Contents for Latitude 5290 2-in-1
Page 1: ...Latitude 5290 2 in 1 Owner s Manual Regulatory Model T17G Regulatory Type T17G002 ...
Page 45: ...Disk driver Figure 4 Disk driver Technology and components 45 ...
Page 47: ...Storage controller drivers Figure 6 Storage controllers Technology and components 47 ...
Page 82: ...82 Software ...
