Installing the battery
Steps
1. Insert the battery into the slot on the laptop.
2. Tighten the M2x3 screws (4) to secure the battery to the laptop.
3. Connect the battery cable to the connector on the system board
4. Install the
.
After working inside your computer
.
Power and volume control board
Removing the power and volume control board
Steps
Before working inside your computer
.
2. Remove the:
a.
b.
c.
3. To remove the power and volume control board:
a. Disconnect the power cable from the connector on the system board [1].
CAUTION:
Ensure that you remove the coin cell battery connector on the system board, to avoid damage
to the battery cable.
b. Peel the adhesive tape [2].
c. Release the volume control board cable from the routing clips .
d. Remove the M2x3 screw (1) that secures the power and volume control board to the laptop [3].
e. Remove the plastic power button from the chassis.
f. Lift the power and volume control board away from the laptop [4].
12
Removing and installing components
