a.
Bottom Cover
b.
Optical Drive
c.
Hard Drive
d.
Battery
6.
Follow the procedures in
After Working Inside Your computer
Removing the RF Holder
1.
Follow the procedures in
Before Working Inside Your Computer
2.
Remove:
a.
Battery
b.
Hard Drive
c.
Optical Drive
d.
Bottom Cover
e.
GPS Holder
f.
WLAN Card
g.
Docking Board
3.
Perform the following steps as shown in the illustration:
a. Flip the antenna cables [1].
b. Disconnect the antenna cables [2].
c. Remove the screw that secure the RF Holder to the computer [3].
d. Lift the RF Holder from the computer [4].
Installing the RF Holder
1.
Place the RF holder on the computer.
2.
Tighten the screws that secure the RF holder to the computer.
3.
Connect the antenna cable.
4.
Route the antenna cable.
5.
Install:
a.
WLAN Card
22
