Replacing the display assembly
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at
Procedure
CAUTION:
Place the computer on a soft and clean surface to avoid scratching the display.
1
Place the display assembly on the palm-rest assembly and align the screw holes on the display hinges with the screw holes on the
palm-rest assembly.
2
Replace the four screws (M2.5x5) that secure the display hinges to the I/O board and system board.
3
Route the antenna cables through the routing guides on the palm-rest assembly.
4
Route the display cable and touch-screen cable on the routing guides on the palm-rest assembly.
5
Connect the display cable to the system board and close the latch to secure the cable.
6
Adhere the tape that secures the display cable to the system board.
7
Connect the touch-screen cable to the system board and close the latches to secure the cables.
8
Adhere the tape that secures the touch-screen cable to the system board.
Post-requisites
1
Replace the
2
Replace the
3
Replace the
.
4
Replace the
.
27
46
Replacing the display assembly
Summary of Contents for Inspiron 7786
