Steps
1. Place the power-button with fingerprint reader into the slot on the palm-rest assembly.
2. Replace the screw (M2x3) that secures the power-button with fingerprint reader to the palm-rest assembly.
3. Adhere the tape that secures the power-button with fingerprint reader cable to the palm-rest assembly.
4. Connect the power-button with fingerprint-reader cable to the power-button board and close the latch.
5. Adhere the tape that secures the power-button with fingerprint reader cable to the palm-rest assembly.
6. Place the power-button bracket on the power-button with fingerprint reader.
7. Replace the screw (M2x3) that secures the power-button bracket to the palm-rest assembly.
Next steps
1. Install the
.
2. Install the
.
3. Install the
.
After working inside your computer
.
System board
Removing the system board
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
. (if applicable)
4. Remove the
M.2 2280 solid-state drive/Intel Optane H10
. (if applicable)
5. Remove the
.
6. Remove the
.
7. Remove the
.
Removing and installing components
41
Summary of Contents for Inspiron 7306 2-in-1
Page 12: ...12 Removing and installing components ...
Page 14: ...Steps 1 Connect the battery cable to the system board 14 Removing and installing components ...
Page 22: ...22 Removing and installing components ...
Page 24: ...24 Removing and installing components ...
