About this task
The following images indicate the location of the battery and provides a visual representation of the installation procedure.
Steps
1. Slide the notch on the battery under the tab on the palm-rest and keyboard assembly and place the battery on the palm-rest
and keyboard assembly.
2. Align the screw holes on the battery to the screw holes on the palm-rest and keyboard assembly.
3. Replace the three screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
4. Connect the battery cable to the connector on the system board.
Next steps
1. Install the
.
After working inside your computer
.
Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
Before working inside your computer
.
2. Remove the
.
About this task
NOTE:
This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed.
NOTE:
The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on
the M.2 card slot:
Removing and installing components
19
