Steps
1. Align the screw holes on the bottom cover with the screw holes on the display-assembly base.
2. Replace the five screws (M3x5) that secure the bottom cover to the display-assembly base and snap the bottom cover back into
place.
Next steps
1. Install the
2. Follow the procedure in
After working inside your computer
.
Stand
Removing the stand
Prerequisites
1. Follow the procedure in
Before working inside your computer
.
CAUTION:
When servicing the computer, place it on an elevated, clean and flat surface. Place the display flat on the
surface with the stand hanging over the edge. It is recommended to remove the stand to avoid accidental damage to
the computer display during servicing.
2. Remove the
.
3. Remove the
.
About this task
The following image indicates the location of the stand and provides a visual representation of the removal procedure.
14
Removing and installing components
