Replacing the speakers
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer
computer, follow the instructions in
. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance
.
Procedure
1
Using the tabs on the speakers, place the speakers in the slots on the
palm rest and keyboard assembly and snap the speakers into place.
2
Route the speaker cable through the routing guides on the palm rest and
keyboard assembly.
3
Adhere the tape that secures the speaker cable to the palm rest and
keyboard assembly.
4
Connect the speaker cable to the system board.
5
Route the power and volume-buttons board cable through the routing
guides on the speaker and the palm rest and keyboard assembly.
6
Connect the power and volume-buttons board cable and the coin-cell
battery cable to the I/O board.
Post-requisites
1
.
2
.
56
Summary of Contents for Inspiron 13 5000 Series 2-in-1
