U.S. FCC Part 68 Statement
The modem complies with Part 68 of the Federal Communications Commission (FCC) rules. On the computer is a label that contains the FCC
registration number and Ringer Equivalence Number (REN) for this device. If requested, this information must be provided to the telephone
company.
l
Equipment Manufacturer
l
Model No: 3CN3BM556-D-100
l
FCC Registration Number: See identification number for modem marked on computer label.
l
Ringer Equivalency Number: See
“
REN
”
number marked on computer label.
The Ringer Equivalence Number (REN) is used to determine the quantity of devices which may be connected to the telephone line. Excessive
REN
’
s on a telephone line may result in the devices not ringing in response to an incoming call. In most areas, the sum of REN
’
s should not exceed
five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total REN
’
s, contact the local telephone
company.
An FCC compliant telephone line cord with a modular plug is required for use with this device. The modem is designed to be connected to the
telephone network or premises wiring using a compatible modular jack which is Part 68 compliant. See installation instructions for details.
If this device causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service
may be required. The telephone company may request that you disconnect the equipment until the problem is resolved.
The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of this equipment.
If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted
service. This equipment cannot be used on telephone company provided coin service. Connection to party line service is subject to state tariffs.
Contact the state public utility commission or public service commission for information.
When programming and/or making test calls to emergency numbers:
l
Remain on the line and briefly explain to the dispatcher the reason for the call.
l
Perform such activities in the off-peak hours such as early morning or late evenings.
Industry Canada (IC) Notice
The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network
protective, operation, and safety requirements. The Department does not guarantee the equipment will operate to the users
’
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications
company. The equipment must also be installed using an acceptable method of connection. In some cases, the inside wiring associated with a
single-line individual service may be extended by means of a certified connector assembly. The customer should be aware that compliance with
the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or
alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user
to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines, and internal metallic water
pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
European Community - CE Notice
Marking by the symbol
indicates compliance of this equipment to the EMC Directive 89/336/EEC, the Low Voltage Directive 73/23/EEC
3Com Corporation
5400 Bayfront Plaza
Santa Clara, CA 95052-8145
NOTE: The United States Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other
electronic device to send any message via a telephone fax machine unless such message clearly contains in a margin at the top or
bottom of each transmitted page or on the first page of the transmission, the date and time it is sent and an identification of the business
or other entity, or other individual sending the message and the telephone number of the sending machine or such business, other
entity, or individual. Refer to your fax communication software documentation for details on how to comply with the fax-branding
requirement.
If trouble is experienced with this equipment or for repair or warranty information, please contact 3Com Corporation. Contact details can
be found in the main body of this manual.
CAUTION: Users should not attempt to make electrical ground connections by themselves, but should contact the
appropriate inspection authority or an electrician, as appropriate.
NOTICE: The
Ringer Equivalence Number
(REN) assigned to each terminal device provides an indication of the maximum number of
terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices
subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.
