EqualLogic FS7500 Installation and Setup
2 Hardware Rack Mounting
Installing the Controllers Into the Rack
See
and follow these steps for each controller:
1. From the front of the rack, pull out the inner sliding rails until they lock into place.
2. Using two individuals on each side of the controller, lift the controller and then lower the rear shoulder
screws on the controller into the rear J-slots on the extended rails (Callout 1 in
).
3. Continue to lower the controller onto the extended rails until all shoulder screws fit in the J-slots (Callout 2).
4. Push the controller inward until you hear the front release latch click.
5. Press the slide-release lock button on each rail (Callout 3) and slide the controller completely into the rack.
Figure 23: Sliding a Controller into the Rack
Securing the Controllers to the Rack
When you push a controller into the rack, the latches on each side of the controller automatically attach the
controller to the front rack posts.
To more securely attach the controller to the rack, see
and follow these steps for each latch:
25
